- 01
When the ductwork or air handler sits up in your attic, foam on the underside of the roof brings that space inside the house, and I'll tell you plainly if your house doesn't need it.
Explore service ↗ - 02
We seal the gaps first, then bring the whole attic to an even depth, including the thin edges near the eaves where older attics here usually come up short.
Explore service ↗ - 03
Blown-in insulation, loose fill blown through a hose, settles in around joists, wiring and odd corners, so it's usually the sensible way to top up what's already up there.
Explore service ↗ - 04
For a whole-house look, I go from the attic down and write out what each space needs, so you can take the work in the order that actually helps.
Explore service ↗ - 05
When old insulation has been soaked by a past roof leak or is full of droppings, we vacuum it out before anything new goes in, so the problem doesn't stay hidden under a fresh layer.
Explore service ↗ - 06
Some houses here sit over a crawl space instead of a slab, and insulating between the floor framing helps with cold floors on winter mornings.
Explore service ↗ - 07
Outside walls in older homes are sometimes empty or thinly filled, so when one room stays hot or cold no matter what the thermostat says, we can fill the walls through small openings.
Explore service ↗ - 08
Air sealing, closing the gaps before insulating, covers can lights, pipes, wire holes and the hatch, so windy days don't pull hot attic air down into your rooms.
Explore service ↗ - 09
Basements are uncommon here, but where a house has one, we insulate the walls in a way that deals with any damp coming through the concrete.
Explore service ↗ - 10
Closed-cell foam, a dense foam that also blocks moisture, fits tight spots where you need a lot of insulation in a little space or a barrier against damp.
Explore service ↗ - 11
Open-cell foam is softer and lighter, and it suits a roofline over an attic full of ductwork where moisture isn't the worry.
Explore service ↗ - 12
For property managers with offices, shops or rentals in Laguna Hills, I walk the space first and write up what it needs, and we plan the work around the people using it.
Explore service ↗ - 13
A plastic barrier laid over the dirt in a crawl space keeps ground moisture from rising into the floor framing and the insulation above it.
Explore service ↗ - 14
We put a vapor barrier where moisture would otherwise work into the insulation and leave it out where it would trap damp, and that's a call I make after seeing the space.
Explore service ↗ - 15
Before any insulation goes into a Laguna Hills attic, we seal the top of the walls, the can lights, the gaps around flues and the hatch, because insulation laid over a draft just hides it.
Explore service ↗ - 16
Retrofit work adds insulation to a finished house without tearing it apart, which is often the fix for the room over the garage that's always the hottest one in the house.
Explore service ↗